Bowdabra

How to use mini bows to top your gift tags with Bowdabra

Hello, everyone! It’s Nancy back with you today, to share another fun Bowdabra project! Embellish your gift tags with adorable mini bows

This time I have used the Mini Bowdabra Bow Making Tool.
This tool is ideal for making smaller bows of all kinds.
I’ve used it to make some tag topper bows.

Here are my finished tags:

mini bows
Aren’t those pretty mini bows?
Here is how I made it:
Supplies Used:
Ribbon of Choice;
Tags;
Skewer.
Follow these steps:
1. Place the Bowdabra Ruler on top of the Mini Bowdabra. One side is in inches and the other side is in centimeters.
2. Cut an 18″ piece of the Bowdabra Bow Wire. Fold it in half. Position it in the tool and tuck the ends underneath the tool, as shown in the photo.
3. Cut a 28″ piece of ribbon. Place the ribbon end at the 3″ mark on the left side. On the right side, turn the ribbon back on itself, creating a loop at the 1″ mark. Insert the ribbon, and form a matching 1″ loop on the left side. The markings on the ruler make it so easy!

4. For the second loop, repeat the process making your loops 1 1/2″, right on top of the first loop.

5. The third and final loop will measure 2″. Repeat the same process again, layering the final loop on top of the previous loops.
6. Insert the Bowdabra Wand into the slot, and scrunch your bow down. Remove the wand.
finishing your mini bows
7. Now pull up the ends of the Bowdabra Wire. Insert the cut ends through the loops. While holding your bow down with one hand, pull on the wire ends with your other hand.
8. Remove the bow from the tool. This is what you have.
9. Tie a knot in your wire. Pull the ribbon ends down, and position the wire as you please. At this point, you could trim the wire, and tuck the ends to the back. Or you could continue on as I did.
10. Wrap the Bowdabra Wire ends around the skewer. If you don’t have a skewer, you could also use a knitting needle or a paintbrush. Remove the skewer and trim the wire ends.
Attach the mini bows to the gift tags
11. Adhere the bow in place at the top of the tag, positioning the wires as you please.
I went on to make two more bows in the same manner.
They’re such a lovely addition to the top of these tags.
They will be wonderful tucked into one of my journals.
* * * * *
Thanks so much for stopping by today!
I’ll be back next month with another fun bow project!
* * * * *
Exit mobile version