After the sprays are in place. We’re going to start with our Bowdabra ribbon for the swag. We are using the fall plaid ribbon and burlap ribbon, which can be purchased on the Bowdabra website.
We are going to start cutting each ribbon 24 in long. These will make 12-inch tails for our bow. Now it’s time to make our loops. We’re going to do one loop on each side of our Bowdabra with the plaid ribbon and cut the excess. Repeat this step with our burlap ribbon. You will need six total loops of each ribbon. Press all the ribbon down with your wand and grab the Bowdabra wire and place the two separate wires into the loop of the other side of the wire and pull tight. Flip swag over and tie wire tightly, then fluff each loop and make your bow full and beautiful.
I’m adding some fall embellishments to the swag. I found these beautiful fall berries and velvet pumpkins. I put a generous amount of hot glue on each embellishment and place them in between the fern and the swags.