Hi everyone, Steph Ackerman here to share a double ribbon bow using the Bowdabra. You can vary the two ribbons for this bow to fit any event or season and add to your wreath.
How to make a double ribbon bow with Bowdabra
Supplies:
Bowdabra Design Tool
Bow Wire
Sheer Ribbon
First, place the Bow Wire in half and then lay it in the Bowdabra and fold it underneath while working.
Place 2×8″ lengths of ribbon in the Bowdabra.
Select a 2nd ribbon and create loops with the same ribbon and twist the ribbon as it passes through the channel.
Create 3 loops on either side of the channel.
Use the bow wand to push the ribbon into the channel.
Continue creating smaller loops, each slightly smaller than the last.
Use the bow wand to push the ribbon into the channel.
Insert the loose wires of the slip knot through the loop and pull up on the Bow Wire. Remove the bow from the Bowdabra, turn to the back and tie a knot.
Fluff out and arrange all the loops on the blow.
Thanks for stopping by.
Steph